Leak diagnosis and tracing
We use a moisture meter and infrared camera to find where water is entering, not just where it is showing. This is included on every call, and it is why we fix the right spot the first time.
24/7 flashing leak response across Hutto and Williamson County
Emergency roof flashing leak repair Hutto TX that stops the water tonight
When water is running down a wall or dripping into your attic, emergency roof flashing leak repair Hutto TX gets a crew on your roof fast. We handle flashing, pipe boot and valley leaks on Hutto homes, trace the actual entry point with a moisture meter and infrared camera, and seal it the same visit. Call 512-543-9356 and we roll.
Careful work. Honest options.
About this service
What emergency roof flashing leak repair Hutto TX actually involves
Emergency roof flashing leak repair Hutto TX is the urgent repair of the metal and membrane transitions on your roof, the spots where water is supposed to be redirected but instead gets in. Flashing covers chimney walls, sidewalls, valleys, drip edge and every pipe boot that punches through your shingles. When one of those pieces lifts, rusts through or loses its sealant, water travels sideways under the shingles and shows up far from the actual hole. We open the area, replace the failed flashing with new material, reset the ice and water shield underneath, and seal it with roof cement rated for Texas heat.
Hutto sits in Williamson County, where summer roof decks hit 150 degrees and spring storms drop two inches of rain in an hour. That cycle cooks the sealant around pipe boots and sidewall flashing until it cracks, and the next storm finds it. Most of the calls we run here start as a stain on a ceiling in Star Ranch or a wet patch in an Emory Farms garage. If you need a roof flashing repair service Hutto homeowners can reach at 2 a.m., we answer the phone and we come out.
- ✓ Same-day leak stop
- ✓ We find the real entry point
- ✓ Materials that survive Hutto heat
- ✓ Documented for your claim
What's included
What our flashing repair includes
Every flashing repair we run in Hutto includes the diagnosis, the materials, the labor and the water test. You get one price for the whole job. If the repair uncovers rotted decking or damaged shingles beyond the flashing, we show you and quote it before we do anything else.
New flashing and underlayment
We remove the failed flashing and replace the ice and water shield and roofing underlayment underneath it. New flashing goes down on top, set to manufacturer spec for your shingle system.
Pipe boot replacement
If a pipe boot is the source, we replace it with a new UV-rated boot sized to your pipe. The old collar is removed, the deck is cleaned, and the new boot is sealed and fastened.
Sealant and roof cement
We seal the repair with roof cement and UV-stable roof sealant rated for Texas heat. This is the layer that keeps the flashing watertight through the next few summers of sun and storm.
Water test and photo record
We run water over the repaired area and check it from the attic before we leave. You get photos of the finished repair and a record of what was replaced, useful for warranty or insurance.
How it works
How our flashing repair call works
You reach a person, not a voicemail. We ask where the water is showing, how long it has been happening, and whether it started after a storm. That tells us whether to bring a tarp for a temporary dry-in or go straight to a full flashing repair. We give you a window and we hold it.
We walk the roof and the attic. A moisture meter and infrared camera show us where water is actually sitting, and a drone inspection covers steep pitches we cannot safely walk. This usually takes 30 to 45 minutes and tells us exactly which flashing is failing.
We show you the failed flashing, explain what caused it, and give you one price before we start. No surprise line items. If the leak is a pipe boot, a valley or a sidewall, you know which one and what it costs to fix it.
We remove the failed flashing, replace the underlayment and ice and water shield, set new flashing, and seal it with roof cement and UV-rated sealant. Nail gun, roofing hammer, utility knife, caulking gun. Most jobs are done in two to four hours.
We run water over the repaired area and watch it from the attic to confirm it sheds the way it should. Then we magnet-sweep the yard and driveway for nails, haul off the old material, and walk you through what we did. You get photos of the repair before we leave.
STEP 01Call and triage
You reach a person, not a voicemail. We ask where the water is showing, how long it has been happening, and whether it started after a storm. That tells us whether to bring a tarp for a temporary dry-in or go straight to a full flashing repair. We give you a window and we hold it.
Tools & methods
Tools and methods we use
Moisture meter
Reads the water content in decking, drywall and framing so we can trace a leak to its source instead of guessing from the stain.
Infrared camera
Shows temperature differences that reveal hidden moisture behind walls and ceilings, even when the surface looks dry to the eye.
Drone inspection
Lets us inspect steep or high roof sections safely and photograph flashing condition without putting a crew at risk.
Ladder stabilizer
Keeps our ladders secure against gutters and siding so we can work safely on Hutto homes with steep or uneven grades.
Nail gun and roofing hammer
Used to reset shingles and fasten new flashing and underlayment to manufacturer spec after the repair.
Caulking gun and roof cement
Applies the UV-rated sealant and roof cement that make the finished flashing watertight against Texas sun and rain.
Real results
Before and after.
Emergency Roof Flashing Leak Repair
Cracked pipe boot in Star Ranch
A homeowner in Star Ranch had a growing ceiling stain above the stairs after every storm. The original pipe boot was 14 years old and the rubber collar had cracked through. Water was running down the pipe and soaking the insulation.
After: We replaced the boot with a new UV-rated unit, reset the flashing around it, and water-tested the repair. The leak stopped the same visit. Two storm seasons later, no stain has returned.
Book this service → Emergency Roof Flashing Leak Repair
Sidewall flashing leak in Emory Farms
An Emory Farms garage had a leak two other companies could not find. The shingles looked fine. Our infrared camera traced it to the sidewall flashing, where the counter-flashing had lifted and water was getting behind the siding.
After: We reset the step flashing and counter-flashing, replaced the underlayment behind it, and sealed the transition. Three hard rains later, the garage is dry. The repair took about three hours.
Book this service →
Emergency Roof Flashing Leak Repair
Valley leak after hail in Hutto
Hail took out the valley flashing on a Hutto home during a spring storm. Water was coming into two rooms at once. The homeowner called at 11 p.m. and we had a tarp on the roof that night.
After: We replaced the valley membrane and flashing and rebuilt the shingle course the next morning. The repair was done before lunch, and we provided photos and a written scope for the insurance claim.
Book this service → Problems we solve
Flashing problems we fix before they spread
A flashing leak rarely stays small. Water travels under shingles, soaks insulation, and reaches drywall and framing before you see a stain. Here are the failures we see most in Hutto and what happens if they wait.
Ask a pro →Ceiling stain that grows after every rain
We trace the stain back to the flashing with a moisture meter and infrared camera, repair the entry point, and water-test it. Most Hutto ceiling leaks we run trace to a failed pipe boot or sidewall flashing.
Water running down a chimney or sidewall
We reset the step flashing and counter-flashing, replace the underlayment behind it, and seal the whole transition. This is a two to four hour repair on most Hutto homes.
Drip in the attic after a hard storm
We find the flashing failure from inside and out, replace the failed material, and confirm the fix with a live water test. You get photos of both the problem and the repair.
Leak at a roof valley during heavy rain
We open the valley, replace the roof valley membrane and flashing, and rebuild the shingle course so water sheds the way it should. Same-day service when you call early.
Transparent pricing
What flashing repair costs in Hutto
$350 - $900 depending on flashing type and damage
Typical 2026 pricing for flashing repair in Hutto runs $350 to $900, depending on the flashing type and how much underlayment or decking has to be replaced. A single pipe boot sits at the low end. Chimney, sidewall or valley flashing with rotted decking pushes toward the top. You get the exact price before we start, and the inspection is free. We do not charge extra for nights or weekends on emergency calls.
A flashing repair costs a fraction of what water damage costs to fix. Stopping the leak now protects your insulation, drywall and framing, and it keeps a small repair from turning into a full roof replacement.
•affects cost
A pipe boot is a quick, low-cost repair. Chimney, sidewall and valley flashing take more labor and material, so they cost more. We tell you which one you have before we quote.
Get a quote ↗•affects cost
If water has rotted the decking or soaked the underlayment, we replace it. That adds material and time. We show you the damage and quote it before we do the work.
Get a quote ↗•affects cost
Steep pitches and tall homes take longer and need more safety setup. A walkable single-story roof is faster to work than a two-story with a steep valley.
Get a quote ↗•affects cost
Matching your existing shingle and flashing to GAF, Owens Corning or CertainTeed systems keeps the repair consistent with the rest of the roof and protects your warranty.
Get a quote ↗ Proof you can check
Credentials and reviews
- GAF Master Elite · GAF
- Owens Corning Preferred · Owens Corning
- HAAG Certified Inspector · HAAG
- NRCA Membership · National Roofing Contractors Association
- OSHA Safety Certification · OSHA
Customer reviews
What Hutto homeowners say
★★★★★
“Water was coming through the ceiling above our stairs after a storm. They came out the same evening, found the pipe boot had cracked, and replaced it plus the flashing around it. Two hours and the leak was done. They water-tested it and showed me the photos. No stain has come back since.”
MT
Marcus T.Homeowner, Star Ranch Hutto TX
✓ Verified“
★★★★★
“We had a leak in the garage that two other companies could not find. RoofGuard traced it with an infrared camera to the sidewall flashing, not the shingles. They replaced the flashing and the underlayment underneath. It has rained hard three times since and the garage is dry.”
DR
Danielle R.Homeowner, Emory Farms Hutto TX
✓ Verified★★★★★
“Called at 11 p.m. after hail took out our valley flashing. They answered, came out early the next morning, and had it repaired before lunch. They also gave me photos and a written scope for my insurance claim. Fair price and no runaround.”
KO
Kevin O.Homeowner, Hutto TX 78634
✓ VerifiedMost flashing repairs in Hutto run $350 to $900 in 2026, depending on the flashing type and how much underlayment has to be replaced. A single pipe boot is usually at the low end. Chimney or valley flashing with rotted decking pushes toward the top. You get the exact price before we start, and there is no charge for the inspection.
The two biggest causes here are UV breakdown of the sealant around pipe boots and sidewall flashing, and wind lifting flashing edges during spring storms. Hail dents and cracks flashing, and clogged gutters back water up under the drip edge. Once the sealant cracks, the next hard rain finds it and water runs sideways under your shingles.
Yes. We carry flashing, pipe boots, underlayment and sealant on the truck, so most same day roof flashing leak repair Hutto TX calls are finished in one visit. Call before early afternoon and we can usually be on your roof that day. Storm nights we run calls in order of how much water is entering the home.
We do, and we are local to Williamson County. RoofGuard Hutto handles emergency flashing repair Hutto TX around the clock, including nights and weekends. Call 512-543-9356 and we will give you an arrival window. If you are in 78634, we are close.
Ready when you are
Need emergency roof flashing leak repair Hutto TX tonight?
We answer 24/7, we carry the parts, and we test the repair before we leave. Call now and we will give you an arrival window. Licensed, insured, and local to Williamson County.
Call Now 5125439356 →
Request an appointment
Call RoofGuard Hutto
We are on call 24 hours a day for active leaks in Hutto and Williamson County. Call 512-543-9356 and describe what you are seeing. Most emergency calls get a tarp or seal the same day, and you get a written scope before any permanent work starts.