Interior moisture mapping
We meter the ceiling, walls, and attic decking around the stain to map how far water has traveled. This tells us whether the leak is directly above or has run along a rafter from another part of the roof.
If water is showing up on your ceiling, we run a full roof leak inspection Hutto TX homeowners call us for after every hard storm. We climb the roof, test the suspect areas, and tell you exactly where the water is getting in. You get a straight answer and a written scope the same day. Call 512-543-9356.

A roof leak inspection Hutto TX is a hands-on diagnostic service that traces water intrusion from the roof deck down to the ceiling stain, then documents the exact failure point. We start with a moisture meter on the interior to map how far the water has traveled, then move to the roof to check flashing, pipe boots, valleys, and shingle courses. An infrared camera confirms wet decking that looks dry to the eye. You get photos, a written scope, and a clear repair recommendation.
Hutto sits in Williamson County, where spring hail and 40 mph north winds work shingles loose and drive rain sideways under the laps. Most of the leaks we diagnose in 78634 are not the obvious hole. They are flashing leaks at a wall intersection, a cracked pipe boot, or a valley that has lost its membrane. That is why a roof leak diagnosis Hutto TX residents trust starts with testing, not guessing, and ends with a repair plan tied to real evidence.
Every inspection covers the full roof system, not just the spot where you see water. Here is what is included in the standard visit. Repairs are quoted separately once we confirm the source, and you approve the scope before any work starts.
We meter the ceiling, walls, and attic decking around the stain to map how far water has traveled. This tells us whether the leak is directly above or has run along a rafter from another part of the roof.
Ridge to eave, we check shingle condition, missing shingles, nail pops, and granule loss. Hail bruising and wind-lifted tabs get photographed and marked so you have a record for insurance.
We inspect every flashing detail, pipe boot, vent, and chimney transition. These are the failure points we find most often on Hutto roofs, especially after a season of thermal expansion and contraction.
Valleys get the heaviest water flow on the roof. We check the membrane, clear debris with a roof snake, and confirm the underlayment and ice and water shield are still doing their job.
You get dated photos of every defect, the confirmed leak source, and a repair scope with materials named. If the damage is storm-related, we format the report for your insurance claim.
We start inside, at the stain. A moisture meter maps the wet zone and tells us how far the water has spread through the decking and insulation. If the ceiling is dry but you smelled damp, an infrared camera picks up the temperature difference. This step takes 15 to 20 minutes.
We set a ladder stabilizer on the gutter line and tie off before stepping onto the roof. On steep pitches we use a pitch hoist to move material safely. Every inspection follows OSHA fall-protection standards, and we photograph the roof surface before we touch anything.
We work the roof in order: ridge vent, pipe boots, flashing at walls and chimneys, then the valleys. A roof snake clears debris from tight transitions so we can see the underlayment. We probe suspect sealant with a utility knife and check for missing shingles, nail pops, and cracked pipe boot collars.
Once we have a suspect, we confirm it. That may mean a controlled water test at the flashing or a second moisture reading after the area dries. We do not call a leak fixed until we can show you the entry point and the path the water took to reach your ceiling.
You get photos of every defect, the confirmed source, and a repair scope with materials listed by name. If the damage is storm-related, we format the report for insurance. You decide what to do next, and there is no pressure to sign anything on the spot.
We start inside, at the stain. A moisture meter maps the wet zone and tells us how far the water has spread through the decking and insulation. If the ceiling is dry but you smelled damp, an infrared camera picks up the temperature difference. This step takes 15 to 20 minutes.
Maps how far water has spread through ceiling, walls, and attic decking so we know the true extent of the intrusion, not just the visible stain.
Picks up temperature differences from wet decking that looks dry to the eye. This is how we find hidden leaks that have not yet reached the ceiling.
Clears debris from valleys and tight transitions so we can inspect the underlayment and membrane underneath instead of guessing at what is buried.
Captures high-resolution images of steep or hard-to-reach roof sections, giving you clear documentation without anyone walking a dangerous pitch.
Keeps our crew safe and stable on the roof so the inspection is thorough rather than rushed. Safety gear is set before anyone steps onto the surface.
Used for probing suspect sealant and making clean test cuts at flashing so we can see the actual condition of the material underneath.

A homeowner in Star Ranch had a spreading ceiling stain after a March storm. Two other companies quoted a full roof replacement based on the stain location. No one had been on the roof with a moisture meter.
After: Our inspection found a cracked pipe boot collar 14 feet from the stain. Water had run along a rafter before dropping through the ceiling. We replaced the boot, tested it with water, and confirmed dry decking. Total repair: $310.
Book this service →
An Emory Farms home had water coming through the garage ceiling after every heavy rain. The roof was 11 years old and a previous contractor had recommended full replacement at $16,000.
After: Inspection with an infrared camera found wet decking 12 feet from the stain. The valley membrane had failed at the transition. We rebuilt the valley with new underlayment and ice and water shield. The leak stopped and the roof has held through two storm seasons.
Book this service →
After an April hail event, a Hutto homeowner's first claim was denied for lack of documentation. The adjuster's report listed no impact marks and no cause of loss. The homeowner had no photos of the roof before the storm.
After: We ran a full inspection with HAAG protocol, marked 60-plus impact points, and photographed each one with a date stamp. The resubmitted claim was approved. The roof was replaced with a GAF system under warranty.
Book this service →These are the calls we get most often. Each one starts with a proper diagnosis, because the visible symptom is rarely the actual source.
Ask a pro →We meter the stain, trace the water path back to the roof, and confirm the entry point with a controlled water test. You get the source, the photos, and a repair scope the same day.
We inspect every flashing detail, probe the sealant, and check the step and counter-flashing. Repairs use code-correct materials matched to your roof system so the fix holds through the next storm season.
Our inspection identifies which boot or vent is leaking, and we replace it with a UV-rated component. This is one of the least expensive repairs we do, usually under $400.
We confirm the valley as the source with moisture readings and a water test, then rebuild it with new underlayment and ice and water shield. The repair is documented so you can see exactly what was replaced.
$180 - $450 depending on roof height, pitch, and number of test areas
Typical 2026 pricing for a roof leak inspection in Hutto runs $180 to $450. The range depends on roof height, pitch, and how many suspect areas we need to test. A single-story ranch with one obvious stain sits at the low end. A steep two-story with multiple valleys and a chimney sits at the high end. If you book the repair with us, we credit the inspection fee toward the work. You get the number before we come out, not after.
A $300 inspection that finds a $310 pipe boot repair saves you from a $14,000 replacement you did not need. That is the whole point. We credit the inspection fee toward the repair when you book with us.
Steep pitches and two-story roofs require more safety setup and slower movement, which adds time. A 12/12 pitch takes roughly twice as long to inspect safely as a 5/12.
Get a quote ↗One stain usually means one suspect zone. Multiple stains or a leak that has traveled can mean three or four test areas, each with its own water test and meter reading.
Get a quote ↗Valleys, dormers, chimneys, and skylights add flashing details to inspect. A simple gable roof has four or five transitions. A complex roof can have twenty.
Get a quote ↗If we can get into the attic, we can meter the decking directly and confirm the source faster. No attic access means more time on the roof and more reliance on exterior testing.
Get a quote ↗“We had a stain on the ceiling for two weeks and two other companies told us we needed a full replacement. RoofGuard ran the inspection, found a cracked pipe boot, and showed us the photos. $310 repair instead of $14,000. They tested it with water before they left and it has been dry through two storms since.”
Marcus T.Homeowner, Star Ranch Hutto TX
✓ Verified“After the April hail I called for a roof leak inspection and they came out the next morning. The inspector marked every impact point and put together a report my insurance adjuster approved without any back and forth. The whole thing took about 80 minutes on the roof. Very thorough and no pressure to sign anything that day.”
Danielle R.Homeowner, Emory Farms Hutto TX
✓ Verified“Leak showed up over the garage after a hard north wind. They used an infrared camera in the attic and found wet decking 12 feet from where the stain was. Turned out to be a valley issue, not the shingles. Fixed it with new underlayment and it has held through every rain since. Straight answers, fair price.”
Kevin S.Homeowner, Hutto TX 78634
✓ VerifiedMost roof leak inspections in Hutto run $180 to $450 in 2026, depending on roof height, pitch, and how many suspect areas we need to test. Steep two-story roofs and complex valley layouts sit at the top of that range. If you book the repair with us, we credit the inspection fee toward the work. Call 512-543-9356 for a straight number before we come out.
It involves three things: finding the entry point, confirming it with a test, and documenting the water path. We use a moisture meter inside, an infrared camera for hidden wet decking, and a controlled water test on the roof at the suspect flashing or pipe boot. You get photos and a written scope the same day. Most diagnoses take 60 to 90 minutes on site.
Once a year, plus after any hail or wind event over 40 mph. Hutto sits in a hail corridor, and a storm that dents your gutters has usually bruised shingles too. Annual inspections catch flashing and pipe boot wear before it becomes a ceiling stain. If your roof is over 12 years old, twice a year is worth it.
We do. RoofGuard Hutto inspects roofs across Hutto, Star Ranch, Emory Farms, and the surrounding Williamson County area. We are a Texas-licensed roofing contractor with HAAG certified inspectors, and we carry full insurance. Call 512-543-9356 and we will get you on the schedule, usually within 24 hours.
Water on your ceiling does not wait, and neither should you. We are a Texas-licensed, fully insured roofing contractor with HAAG certified inspectors. Call now and we will get you scheduled, usually within 24 hours. Same-day slots open for active leaks.
Schedule Inspection 5125439356 →We are on call 24 hours a day for active leaks in Hutto and Williamson County. Call 512-543-9356 and describe what you are seeing. Most emergency calls get a tarp or seal the same day, and you get a written scope before any permanent work starts.